由于混凝土?xí)诙虝r(shí)間內凝固成硬塊,且對鋼材和油漆有一定的腐蝕性,所以每次使用混凝土貯罐后,洗凈粘附在混凝土貯罐及進出料口上的混凝土是每日維護需要認真進行的工作。其中包括:
Since the concrete will solidify into hard blocks in a short time and have certain corrosivity to steel and paint, cleaning the concrete adhered to the concrete storage tank and the inlet and outlet after each use of the concrete storage tank is a daily maintenance work that needs to be carried out carefully. These include:
a.每次裝料前用水沖洗進料口,使進料口在裝料時保持濕潤;
a. Wash the inlet with water before loading each time to keep the inlet moist during loading;
b.在裝料的同時向隨車自帶的清洗用水水箱中注滿水;
b. Fill the cleaning water tank with water while loading;
c.裝料后沖洗進料口,洗凈進料口附近殘留的混凝土;
c. Wash the inlet after loading and clean the residual concrete near the inlet;
d.到工地卸料后,沖洗出料槽,然后向混凝土貯罐內加清洗用水30—40L;在車輛回程時保持混凝土攪拌罐車混凝土貯罐正向慢速轉動;
d. After unloading at the construction site, wash the discharge tank, and then add 30-40l of cleaning water to the concrete storage tank; When the vehicle returns, keep the concrete mixing tank truck and the concrete storage tank rotating forward and slowly;
e.下次裝料前切記放掉混凝土貯罐內的污水;
e. Remember to discharge the sewage in the concrete storage tank before the next loading;
f.每天收工時清洗混凝土貯罐及進出料口周?chē)?,不粘有水泥及混凝土結塊。
f. Clean the concrete storage tank and around the inlet and outlet at the end of each day, and there shall be no cement and concrete caking.
以上這些工作只要不認真進行,就會給以后的工作帶來很大的麻煩。
As long as the above work is not carried out seriously, it will bring great trouble to the future work.
1、磨合過程:混凝土攪拌車的磨合里程為1000-2500,進口車的磨合期則更長一些,多數為1500-3000。磨合期分為三個階段。行駛里程100時為磨合初期,200時為初磨合程度,3000就可磨合形成氧化膜。
1. Running in process: the running in mileage of concrete mixer truck is 1000-2500 km, while that of imported truck is longer, mostly 1500-3000 km. The running in period is divided into three stages. When the driving mileage reaches 100km, it is the initial running in stage; when the driving mileage reaches 200km, it is the initial running in stage; when the driving mileage reaches 3000km, it can form oxide film.
砼牛自動上料攪拌車
Automatic concrete feeding mixer
2、行駛速度:磨合期內應盡量低速行駛。一般情況下,載重混凝土攪拌車車速不宜超過45/小時,混凝土攪拌車的車速車速應在50-80/小時以?xún)?nèi)。同時,在起步前不要讓發動機怠速運轉太長時間,30秒左右即可起步。初駛期300以?xún)?nèi)應避免緊急制動。
2. Driving speed: try to drive at a low speed during the running in period. Generally, the speed of truck concrete mixer should not exceed 45 km / h, and the speed of concrete mixer should be within 50-80 km / h. At the same time, don't let the engine idle for too long before starting. You can start in about 30 seconds. Emergency braking shall be avoided within 300 km in the initial driving period.
The above is a detailed introduction to the automatic mixer, which I hope will be helpful to you If you have any questions, please contact us We will provide you with professional service http://842233.cn/